Всем привет. пока был в отпуске от NAS пришли вот такие письма
В 11 часов - три сразу
1.
The hard disk 4 in the Disk Group on flylinkdc-serv has failed; please replace it.
2.
Volume 1 on flylinkdc-serv has entered degraded mode. (Total number of hard disks: 4; Number of active hard disks: 3) Please identify the cause of degradation and take corrective action.
To repair the volume, please replace the defected disks with new ones. For more information, visit Synology's website at http://www.synology.com and read the tutorial: How to repair a volume on DiskStation.
3.
The hard disk 4 on flylinkdc-serv had an I/O error, but it is working properly now after several retries. It might have been caused by bad sectors. If this error occurs again, please back up your data and run the S.M.A.R.T. test on your hard drive to examine the hard drive status.
в 12:42
The hard disk 4 on flylinkdc-serv had an I/O error, but it is working properly now after several retries. It might have been caused by bad sectors. If this error occurs again, please back up your data and run the S.M.A.R.T. test on your hard drive to examine the hard drive status.
в 13:53
The temperature of disk ST2000DM001-1CH164 is -1 ºC, which is not within the operating temperature, 0 ºC ~ 60 ºC.
Please keep your disks within acceptable operating temperature.
в 23:27
1.
System volume (Root) on flylinkdc-serv has entered degraded mode. (Total number of hard drives: 4; number of active hard drives: 3)
Please reboot the system, and it will repair itself automatically on startup.
2.
System volume (Swap) on flylinkdc-serv has entered degraded mode. (Total number of hard drives: 4; number of active hard drives: 3)
Please reboot the system, and it will repair itself automatically on startup.
диски у меня все ST2000DM001 не для NAS - не смог купить.
Сам винт пока не вытаскивал
сейчас есть возможность купить диск для NAS но хотел заодно расширить объем с 2 Тб до 4 Tb
но тут пишут
http://macsynology.wordpress.com/2011/05/0...led-hard-drive/
что рекомендуется выбирать вообще одного производителя и размер если не хотите потерять все при процессе восстановления ![]()
что делать?